T series spiral bevel gear steering box product introduction: 1.T series primary spiral bevel gear transmission box, standardized, multi-variety, speed ratio 1:1, 1.5:1, 2:1, 2.5:1, 3:1, 4:1, 5:1 are all actual transmission ratios, with an average efficiency of 98%. 2. There are single axis, double horizontal axis, single vertical axis, double vertical axis optional. There are two kinds of exterior structures: foot installation and end face installation. 3. Spiral cone teeth can be positive and negative operation, low-speed or high-speed transmission is stable, and low noise, small vibration, large bearing capacity. 4. When the speed ratio is not 1:1, the horizontal axis input, the vertical axis output is deceleration, the vertical axis input, the horizontal axis output is speed increase. Note: 1. When the speed ratio is not 1:1, please confirm or inform the input shaft. Select the horizontal axis input as deceleration and the vertical axis input as acceleration. After the installation orientation and size are determined, the positions of the two shafts cannot be changed. 2. The bearing capacity of the commutator box shall be calibrated for multiple linkage outputs. TB series spiral bevel gear steering box features: TB series is a new product developed and designed on the basis of T series. With a simple interruption, reversing, clutch mechanism, can achieve the following 4 functions: 1 The input direction is unchanged, and the output can be selected as forward, reverse, and stationary without turning. 2 There are single-axis output and dual-axis output. When dual-axis output, you can stop left, turn right, stop right, stop at the same time, and run at the same time. The direction can be the same or the opposite. 3 speed ratio of 1:1, other speed ratio of another consultation. 4 models are TB6, TB7, TB8, TB10, TB12, TB16, and other models are separately consulted.